Sciweavers

1379 search results - page 31 / 276
» Elements of low power design for integrated systems
Sort
View
ICCD
2004
IEEE
113views Hardware» more  ICCD 2004»
15 years 10 months ago
Toward an Integrated Design Methodology for Fault-Tolerant, Multiple Clock/Voltage Integrated Systems
Abstract - This paper describes a communicationcentric design methodology that addresses the fundamental challenges induced by the emergence of truly heterogeneous Systems-on-Chip ...
Radu Marculescu, Diana Marculescu, Larry T. Pilegg...
MICRO
2000
IEEE
95views Hardware» more  MICRO 2000»
15 years 5 months ago
Very low power pipelines using significance compression
Data, addresses, and instructions are compressed by maintaining only significant bytes with two or three extension bits appended to indicate the significant byte positions. This s...
Ramon Canal, Antonio González, James E. Smi...
VLSID
2009
IEEE
108views VLSI» more  VLSID 2009»
16 years 2 months ago
Metric Based Multi-Timescale Control for Reducing Power in Embedded Systems
Abstract--Digital control for embedded systems often requires low-power, hard real-time computation to satisfy high control-loop bandwidth, low latency, and low-power requirements....
Forrest Brewer, João Pedro Hespanha, Nitin ...
112
Voted
CASES
2007
ACM
15 years 5 months ago
A low power front-end for embedded processors using a block-aware instruction set
Energy, power, and area efficiency are critical design concerns for embedded processors. Much of the energy of a typical embedded processor is consumed in the front-end since inst...
Ahmad Zmily, Christos Kozyrakis
131
Voted
FAST
2011
14 years 5 months ago
Exploiting Half-Wits: Smarter Storage for Low-Power Devices
This work analyzes the stochastic behavior of writing to embedded flash memory at voltages lower than recommended by a microcontroller’s specifications to reduce energy consum...
Mastooreh Salajegheh, Yue Wang, Kevin Fu, Anxiao J...